24
Maintenance &
Lubrication
Never allow anyone under
the attachment at any
time.
Do not modify the attachment. Modifications may weaken
the integrity of the attachment and may impair the safety,
function, life, and performance of the earth auger.
When making repairs or servicing the earth auger, use
only parts that meet original equipment manufacturer's
standards and requirements.
Never check pressurized system for leaks with your bare
hand. Wear proper hand and eye protection and use wood
or cardboard when searching for suspected leaks. Oil
escaping from pinhole leaks under pressure can penetrate
skin and create a serious medical emergency. If any fluid
is injected into the skin, gangrene, blood poisoning, even
death may result. Obtain medical attention immediately.
Maintenance Interval
Inspect the attachment for any damage, worn parts, or
cracked welds. Repair or replace as necessary.
Before each use
Check for damaged or missing safety signs. Replace as
necessary.
Before each use
Coat the inside diameter of the auger or extension collar
with grease.
Each time an auger or extension
is attached
Check all fasteners. Ensure they are tight and secure.
(Refer to Torque Values Chart.) Replace as necessary.
Daily
Check all hydraulic components for leaks or wear.
Repair or replace as necessary.
Daily
Check planetary gear oil level to assure proper
lubrication is maintained. Check by removing the front
fill plug - with the drive unit angled approximately 30°
from vertical.
Daily
Check for clean hydraulic oil. At all times, keep dirt and
other contaminants from entering the hydraulic
system during connecting and disconnecting the
hydraulic system. Always use dust caps and plugs on all
quick disconnects when not in use.
Daily
Change planetary gear reduction oil after first 500 hours
of operation or 6 months, then every 2000 hours or 12
months, whichever comes first. Use heavy duty extreme
pressure lubricant API-GL-5 85W-140 for filling the
planetary gear reduction. Approximate oil capacity is
.90 quarts (.85 liters).
After 1st 500 hours, then every
2000 hours or yearly
Proper servicing and maintenance are key to the long life of any attachment. Careful
inspection and routine maintenance helps avoid costly downtime and repair. Do not use the
earth auger with any damaged parts.
Personal protection
equipment including
hard hat, safety glasses,
safety shoes, and gloves
are recommended during
assembly, installation,
operation, maintenance,
service, removal, or
movement of the earth
auger. Do not allow long
hair, loose fitting
clothing, or jewelry to be
around moving and/or
rotating parts.
Oil level
30°
To Next Page
Loading...
