EasyManua.ls Logo

Darkglass Electronics Microtubes X Ultra - Software and Compliance; Darkglass Suite Utility; Regulatory Compliance

Default Icon
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Darkglass Suite
Download the free Darkglass Suite software from www.darkglass.com/suite
to configure the pedal, load new impulses and download firmware updates.
Darkglass Suite comes with a selection of cabinet IRs made by some of our
artists. It also allows you to load your own IRs in WAV and AIFF formats and
organize your IR files. See the online manual of Darkglass Suite for more
information.
The Bus Compressor on the Microtubes X Ultra can be enabled for the clean
channel in Darkglass Suite. You can enable tooltips ('?' symbol in the top
right corner) and hover the mouse over different functions for additional
information.
Disclaimer
In the interest of continuous improvement, specifications are subject to
change without notice. If you have any questions, please don’t hesitate to
contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the requirements as
set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE.
EMC / EMI
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the vequipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
· Consult the dealer or an experienced radio / TV technician for help.

Related product manuals