Avg: (Shown only when using groups are used and using average setting). Allows
you to choose how the average temperature of groups is made up. Range of
selection is: All Groups (default), Highest 2 Groups to Highest 15 groups.
Refresh Rate: This is how often the highest sensors and groups are determined.
Range of adjustment is 5m, 15m, 30m, 45m, 1Hr, to 24Hrs with a default of 5m.
Offset Setpoint: (Default is No). When enabled, causes the cooling set point to be
offset when the fan runs at 100%. The set point will be offset at a rate of -0.1°F per
minute. The maximum offset is limited by the set point’s lower limit of adjustment.
R
ac
k
S
e
tt
i
n
g
s
S
n
s
r
#
G
r
p
01
C
on
t
r
o
l
+
A
l
a
r
m
A
02
C
on
t
r
o
l
+
A
l
a
r
m
A
03
D
i
s
a
b
l
e
d
A
04
C
on
t
r
o
l
+
A
l
a
r
m
B
06
C
on
t
r
o
l
+
A
l
a
r
m
B
Note: The Rack Settings screens are only displayed when the rack mode is
enabled.
Select a function for each installed sensor and which group (if groups are used)
that the sensor should be part of. Selectable functions are:
Disabled – The temperature and alarms of the sensor are disabled.
Monitor Only – The temperature of the sensor is displayed, but not used to
make up the average or highest rack temperature.
Monitor+Alarm – The temperature of the sensor is displayed, but not used
to make up the average or highest rack temperature. The high and low rack
temperature alarms (set in the Alarms and Limits menu) are enabled.
Control – (Default setting) the temperature of the sensor is used to make
up the average or highest rack temperature.
Control+Alarm – The temperature of the sensor is used to make up the
average or highest rack temperature. The high and low rack temperature
alarms (set in the Alarms and Limits menu) are enabled.
To Next Page
Loading...
