R
e
t
u
r
n
A
i
r
A
l
a
r
m
s
F
i
r
e
s
t
a
t
S
e
t
po
i
n
t:
150
•
H
i
T
e
m
p
A
l
a
r
m
:
Y
e
s
S
e
t
po
i
n
t:
80
•
Lo
T
e
m
p
A
l
a
r
m
:
Y
e
s
S
e
t
po
i
n
t:
60
•
Firestat Setpoint: This is the maximum temperature of the return air temperature
for the firestat alarm to occur and it cannot be disabled. A firestat alarm will cause
the unit to turn off until the alarm is no longer active. The range of adjustment is
100 to 150°F with a default setting of 150°F.
Hi Temp Alarm: When set to “Yes” (default) the alarm is enabled. When the return
air temperature rises above the set point, a high temp alarm will occur. During this
alarm, the fan will run at the maximum speed setting (plug fan only). The range of
set point adjustment is 70 to 90°F (70 to 120°F on CW units) with a default setting
of 80°F.
Lo Temp Alarm: When set to “Yes” (default) the alarm is enabled. When the
return air temperature drops below the set point, a low temp alarm will occur.
During this alarm, the fan will run at the maximum speed setting (plug fan only).
The range of set point adjustment is 70 to 55°F with a default setting of 60°F.
R
ac
k
S
e
n
s
o
r
A
l
a
r
m
s
H
i
T
e
m
p
A
l
a
r
m
:
90
•
Lo
T
e
m
p
A
l
a
r
m
:
70
•
N
o
t
e
:
E
n
a
b
l
e
of
a
l
a
r
m
s
are sensor
s
e
tt
i
n
g
s
The rack sensor alarm screen will only appear if Rack Sensors are installed,
enabling the feature in the Factory menu.
The individual rack sensors are configured in the Factory menu where the alarm
may be enabled (Monitor+Alarm and Control+Alarm) or disabled (Monitor Only and
To Next Page
Loading...
Need help?
General
