Sentry K350 hardware encrypted USB flash drive - User Guide
you must now follow the getting started process as shown in the Getting Started and the formatting
your K350 section of this manual.
Zeroize Drive
Available for ADMIN
This feature allows the administrator to zeroize the drive. Performing this action deletes all the data,
removes the user and administrator passwords. The Data Encryption Key (DEK) will also be wiped
and regenerated.
NOTE: Zeroize will not remove the configurations set by the administrator.
How to Zeroize your K350
1. In the Configuration menu select Zeroize Drive, confirm with Enter-button. When your device
asks for “Zeroize Drive” select Yes, confirm with Enter-button. Selecting No will cancel the
Zeroize process.
2. Select Yes, confirm with Enter-button. Selecting No will cancel the Zeroize process.
3. When your K350 shows the “Confirm Delete all drive data?” prompt, select Yes, confirm with
Enter-button. Selecting Cancel will cancel the Zeroize process.
4. Upon successfully completing the Zeroize process, you will see “Please initialize and reformat
the drive”, confirm with Enter-button to continue.
NOTE: You must now follow the getting started process as shown in the Getting Started and the
Formatting your K350 section of this manual.
Strong Password
Available for ADMIN
This feature allows the device administrator to enable the password requirement to be stronger
than the default for both ADMIN and USER. When enabled the passwords must have at least one
letter, one number and one special character.
1. In the Configuration Menu select/confirm Strong Password.
2. Select Enable or Disable, confirm with Enter-button. The device goes back to the Configura-
tion Menu after the confirmation.
Password Length
Available for ADMIN
The device administrator can use this feature to set the minimum required password length. It can
be set between the minimum of 8 to a maximum of 64. Tapping Default will reset the counter to “8”.
1. In the Configuration Menu select/confirm Password Length.
2. Select Change or Cancel, confirm with Enter-button.
3. Enter the new minimum password length number, between 8 and 64. Confirm with Enter-
button, the device goes back to the Configuration menu after the confirmation.
© 2021 DataLocker Inc. All rights reserved. 12
To Next Page
Loading...
