Datalogic Applications
User’s Manual 103
3. If User Access Control (UAC) is enabled on your computer,
authorize the installer to run. (UAC is enabled by default on all
supported Windows operating systems, but it can be disabled by
default. If you do not see this prompt, UAC may have been
disabled.)
4. Follow on-screen prompts to finish installing DXU.
5. Follow on-screen prompts to finish installing Datalogic Device
Support drivers.
Controls
DXU Agent Controls
The most important thing to remember about changing DXU Agent
settings is that the DXU Agent Service must be disabled before
changing settings, and it must be enabled again after changing
settings to put those settings into operation.
Find these settings in the DXU Agent application on the device.
1. Launch the DXU Agent application.
2. Tap the Menu button to display the menu.
3. Tap the Settings button.
To Next Page
Loading...
