Datalogic Applications
122 DL-Axist™
Tasks
Connect to a Device via USB
You can connect to the DL-Axist directly by connecting it to your PC
with a USB cable. DXU will connect to it directly without any further
set-up.
1. Launch DXU.
2. Connect your device to your PC with a USB cable.
3. Click the device’s button in the “Available Device” list.
Connect to a Device via Network Manually
If DXU Agent on the device has its “Enable Discovery Manager”
feature enabled and DXU has “Automatic Discovery of Devices”
enabled under Advanced Settings, then clicking Refresh should
display it in the “Available Device” list if it is in the same subnet.
However, if you want to manually add a device in DXU make sure
both device and system are in the same subnet and do this:
1. On DXU’s main view, click the “Add Device“button;
2. In the “Add Device“dialog, enter the IP address of the device and
optionally its port if it is has been changed from the default;
To Next Page
Loading...
Need help?
General
