Datalogic Applications
User’s Manual 123
3. Click the OK button to complete.
The added device will display on the left side of the console under
Available Device.
Connect to a Device via Network Using Scan2Pair
These steps assume you already have your network set up, and you
already have your printer set up. To connect a device to a Wi-Fi
access point and to DXU using default settings, do this:
1. Launch DXU.
2. Click the Scan2Deploy button on DXU’s main view.
3. Enter the SSID and Password for the Wi-Fi access point that
your device will use to connect to your network.
NOTE
You will see the IP Address and port details displayed on
DXU’s main view along with the model name, serial
number, and an illustration of the device.
NOTE
You can also directly connect the device to DXU using
USB.
NOTE
In most cases you should be able to leave other fields
with their default values. You may, of course, change
those values as needed to work with your network setup.
To Next Page
Loading...
Need help?
General
