Battery
18 Falcon™ X4
Replace the Battery
To replace the battery pack, follow the steps below:
1. Turn off the Falcon X4 (press the power key and wait for device
power off).
2. Press the latch release button, pull the battery latch down and
remove the battery pack.
3. Insert the new battery pack into the slot (Install the Battery on
page 15).
WARNING
Use only Datalogic approved batteries and accessories
for battery charging.
Risk of explosion if battery is replaced by an incorrect
type.
Dispose of used batteries according to the instructions.
Il y a risque d’explosion si la batterie est remplacée par
une batterie de type incorrect.
Mettre au rebut les batteris usagées confor mément aux
instructions.
To Next Page
Loading...
