Datalogic FireScan D131 User Manual

First Start-Up
Connect FireScan™
to Host
Does a dialog
box appear
warning that Bus
power is not
sufficient?
Select desired USB
interface code
(USB-KBD is default)
Disconnect reader
at Host
Connect external
power supply to
cable and power up
Reconnect reader
cable to Host and
close dialog box
NO
YES
Read test codes.
Reader is READY
Load drivers
(if requested)
Load drivers
(
if re
q
uested
)
Green LED blinks
Green LED off - BEEP OK
BEEP OK
Green LED off
Successive start-ups will automatically recognize the previously
loaded drivers. If external power is used, verify that external
power is already supplied.
Successive Start-Ups
NO
YES
Read test codes.
Reader is READY
Green LED blinks
Green LED off - BEEP OK
BEEP OK
Connect FireScan™
to Host
Disconnect reader
at Host
Connect external
power supply to
cable and power up
Reconnect reader
cable to Host and
close dialog box
Does a dialog box
appear warning
that Bus power is
not sufficient?

Datalogic FireScan D131 Specifications

General

Brand	Datalogic
Model	FireScan D131
Category	Barcode Reader
Language	English