Need help?Do you have a question about the Datalogic Touch TD1100 Family and is the answer not in the manual?
General| Scanner Type | Linear Imager |
|---|---|
| IP Rating | IP42 |
| Print Contrast Ratio (Minimum) | 15% |
| Decode Capability | 1D barcodes |
| Operating Temperature | 0 to 50 °C / 32 to 122 °F |
| ESD Protection (Air Discharge) | 16 kV |
| ESD Protection (Contact Discharge) | 8 kV |
| Input Voltage | 5 VDC ± 5% |
| Interface | USB, RS-232 |
| Drop Resistance | 1.5 m / 5 ft |
| Storage Temperature | -20 to 70 °C / -4 to 158 °F |
| Ambient Light | Up to 100, 000 lux |
| Current | 100 mA (typical) |
| Humidity | 5% to 95% (non-condensing) |
| Power Supply | External power supply |
| Resolution | 0.1 mm (4 mil) |
Overview of the Touch TD1100 series readers.
Describes the purpose and content of the Product Reference Guide.
Information on accessing technical support via the Datalogic website.
Steps to connect and communicate the reader with its host.
Guidance on connecting the appropriate interface cable to the reader.
Guides on selecting the correct interface type for the reader.
Scan programming bar codes to set interface type.
Links to sections for configuring RS-232, USB, Keyboard, OEM.
Options for configuring specific bar code label types.
Sets reader's baud rate to match host device.
Specifies parity for sending and receiving data.
Specifies country/language for keyboard interface.
Identifies reader as table top or handheld for USB-OEM.
Specifies the speed of the Wand output signal.
Adds ASCII characters as prefixes or suffixes to bar code data.
Configures customizable codes to identify bar code types.
Explains indications for power, good reads, and errors.
Configures various scanning modes and behaviors.
Controls processing of coupon labels.
Configuration options for UPC-A symbology.
Enables or disables reading Code 39 bar codes.
Enables or disables reading Code 128 bar codes.
Enables or disables reading I 2 of 5 bar codes.
Enables or disables reading Codabar bar codes.
Detailed parameters for the RS-232 interface.
Details on supported bar code types and their configurations.
Default settings for features common to all interfaces.
Default settings for symbologies.
Provides typical representations of 1D symbology types.
Bar codes used to enter numbers and characters from a keypad.
Selects scancode tables for control character emulation.
To Next Page