Scanning Features Enter/Exit Programming Mode
Product Reference Guide
83
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
"Scanning Active Time" on page 275 for more detailed programming instructions.
Stand Mode Flash
Enables/disables the LED flash when the reader is in Stand Mode.
$CSNET
Select Scanning Active Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
005 = Scanning is active for 5 Seconds
$CSMFL00
Stand Mode Flash = Disable
$CSMFL01
Stand Mode Flash = Enable
To Next Page
Loading...
