Enter/Exit Programming Mode Codabar
182
Touch TD1100
Codabar Set Length 1
This feature specifies one of the bar code lengths for Codabar Length Control. Length 1 is the
minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length
Mode. Length includes the bar code’s start, stop, check and data characters. The length must
include at least one data character.
The length can be set from 3 to 50 characters. See "Set Length 1" on page 278 for more detailed
programming instructions.
$CCBL1
Select Codabar Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
03 = Length 1 is 3 Characters
To Next Page
Loading...
