Enter/Exit Programming Mode Character Conversion
66
Touch TD1100
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4 character pairs
represented in hexadecimal ASCII values. The first character in the pair is the character that will
be converted. The second character in the pair is the character to convert to. If the character to
convert in a pair is FF, then no conversion is done. See "Character Conversion" on page 270 for
more detailed programming instructions.
$CLFCH
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF(N
o character conversion)
To Next Page
Loading...
