Datalogic Touch TD1100 Family - ABC Codabar Dynamic Concatenation Timeout; ABC Codabar Force Concatenation

Enter/Exit Programming Mode ABC Codabar
188 Touch TD1100
ABC Codabar Dynamic Concatenation Timeout
This parameter specifies the timeout in 10-millisecond ticks used by the ABC Codabar
Dynamic Concatenation Mode. The timeout can be set within a range of 05 to 255 in 10ms
increments. A setting of zero specifies no delay.
ABC Codabar Force Concatenation
Forces labels starting or ending with D to be concatenated.
$CKBQI
Select ABC Codabar Dynamic Concatenation
Timeout Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
10 = Quiet Interval of 200 ms
$CCBFC00
ABC Codabar Force Concatenation = Disable
$CCBFC01

ABC Codabar Force Concatenation = Enable
DEFAULT