Error Codes
Product Reference Guide
285
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not passed its
automatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the
reader is reset, the sequence will be repeated. The following table describes the LED
flashes/beep codes associated with an error found.
Label Program-
ming Mode Accep-
tance of
Programming
Configuration option(s) have been
successfully programmed via
labels and the reader has exited
Programming Mode.
N/A
Reader sounds one high frequency
beep and 4 low frequency beeps
followed by reset beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned. N/A
Reader sounds two times at low
frequency and current volume.
Programming Mode
- The following indications ONLY occur when the reader is in Programming Mode.
INDICATION DESCRIPTION LED BEEPER
NUMBER OF
LED
FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assistance
2 Interface PCB
5 [Reserved]
6 Digital PCB
To Next Page
Loading...
