Mounting the Scanner
12 Gryphon™ GFE4400
The following is an example of a possible connection scheme for the User
Interface:
Figure 7. Sample Connection Scheme
Good Read Beep Interface
The Beep Interface connection (J3) provides the integrator a means to tap
the engine's good read beep signaling and interface with an external audio
device.
The Beep Connection (J3) is a Molex part number, 53261-0271,
1.25mm Pitch PicoBlade™ 2 Circuit Header. To attach to this SMT
Right Angle Header, the integrator should use the Molex mating plug,
51021-0200 and wire crimp terminal, 50079-8000 or equivalent.
To Next Page
Loading...
