HHD II
126
4.9 CONFIGURATION COPY COMMAND
Procedure
:
c
Connect the master (correctly configured reader) and the slave (reader to be
configured) together through two RS232 serial interface cables and external
power supply. Accessory cables and power supply are available from your
Datalogic distributor to provide this connection.
RS232 Cables: CAB363 & CAB364
or CAB320 & CAB328
Power Supply: PG5
d
Using the slave device, read the Restore Default barcode and then the RS232
interface barcode from par. 2.1.2 of this manual or from the Quick Reference
Manual.
e
With the master device, read the Configuration Copy barcode below.
Copy Configuration
Ì$+ZZ0$-*Î
The configuration will be copied from the master to the slave device. The slave
device signals the end of the procedure with a series of beeps.
Note: The master device can be configured for any interface.
To Next Page
Loading...
Need help?
General
