Magellan 9300i/9400i/9800i Setup Guide
A Global Payments Company Page 12
Last-Digit Capture
7 Scan this barcode to enter programming mode. After scan, the green light on the top of the
scanner/scale will flash, indicating the device is in programming mode.
8 Enable/Disable last-digit capture with these barcodes:
To enable scanning of the last digit of UPC-E barcode numbers, scan this barcode and wait for the
double beep to confirm success.
To disable scanning of the last digit of UPC-E barcode numbers, scan this barcode and wait for the
double beep to confirm success.
9 To finalize last-digit capture configuration, scan this barcode. After scan, the device will reboot and
the green lights will stop flashing, indicating the device has exited programming mode.
To Previous Page
Loading...
