Datalogic Magellan 9300i - Physical Parameters

Magellan 9300i/9400i/9800i Setup Guide
A Global Payments Company Page 4
Sequence Two
1 After scan, the green light on the top of the scanner/scale will flash, indicating the device is in
programming mode.
2 After scan, the device will beep twice to indicate that it scanned correctly.
3 After scan, the device will beep twice to indicate that it scanned correctly.
4 After scan, the device will beep twice to indicate that it scanned correctly.
5 After scan, the device will beep twice to indicate that it scanned correctly.