COMPLIANCE
Only connect Ethernet and dataport connections to a network which has routing only within the plant or building and
no routing outside the plant or building.
EMC COMPLIANCE
In order to meet the EMC requirements:
connect reader chassis to the plant earth ground by means of a flat copper braid shorter than 100 mm;
connect pin “Earth” of the CBX connection box to a good Earth Ground;
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only. This product is intended to be connected to a UL
Listed Computer (LPS or “Class 2”) which supplies power directly to the reader or a UL Listed Direct Plug-in Power
Unit marked LPS or “Class 2”.
EAC COMPLIANCE
Customs Union:
The CU Conformity certification has been achieved; this allows the
Product to bear the Eurasian mark of conformity.
LED SAFETY
LED emission according to EN 62471
LASER SAFETY
All Matrix 120s contain one aiming Laser source used to position the reader.
These products conform to the applicable requirements of IEC 60825-1 and comply with 21 CFR 1040.10 except for
deviations pursuant to Laser Notice N° 50, date June 24, 2007. This product is classified as a Class 1M laser product
according to IEC 60825-1 regulations.
WARNING: Use of controls or adjustments or performance of procedures other than those specified herein may
result in exposure to hazardous visible laser light.
LASER RADIATION DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS CLASS 1M LASER PRODUCT
Disconnect the power supply when opening the device during
maintenance or installation to avoid exposure to hazardous laser light. The laser beam can be switched on or off
through a software command.
CE COMPLIANCE
CE marking states the compliance of the product with essential requirements listed in the applicable European
directive. Since the directives and applicable standards are subject to continuous updates, and since Datalogic
promptly adopts these updates, therefore the EU declaration of conformity is a living document. The EU declaration
of conformity is available for competent authorities and customers through Datalogic commercial reference contacts.
Since April 20th, 2016 the main European directives applicable to Datalogic products require inclusion of an
adequate analysis and assessment of the risk(s). This evaluation was carried out in relation to the applicable points
of the standards listed in the Declaration of Conformity. Datalogic products are mainly designed for integration
purposes into more complex systems. For this reason, it is under the responsibility of the system integrator to do a
new risk assessment regarding the final installation.
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of Datalogic could void the
authority to use the equipment. This device complies with PART 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
To Next Page
Loading...
