During the reader startup (reset or restart phase), all the LEDs blink for one second. The single push button gives
immediate access to the following relevant functions:
Test Mode with bar graph visualization to check
static reading performance.
Focus (Aim) turns on the laser LED to aim the reader
at the target. The target should be placed 8 mm to
the left and centered vertically with respect to the
aiming pattern (cross).
Setup to self-optimize and auto-configure photometry
parameters.
Learn to self-detect and auto-configure for reading
an unknown barcode (by type and length). Only one
symbology type can be saved using this method.
Performing Autolearn on a second symbology will
overwrite the first one.
To Next Page
Loading...
