SETTINGS
30
MEMOR™ K
Target Mode
If enabled, when the scan button is pressed, the scanner will project an aiming pattern
to assist in centering over the barcode before scanning. Tap Target mode to select the
desired targeting behavior:
No Delay
Target mode is disabled.
Spot Timeout
Scanning takes place after a programmable time upon pressing the scan button. Tap
Target timeout to set the duration of the spot:
Release Scan
Scanning takes place after the scan button is released. Tap Release scan timeout to set
the scanning timeout after releasing the scan button:
To Next Page
Loading...
Need help?
General
