To Next Page

To Previous Page

Using the PowerScan™ PD9330

4 PowerScan™ PD9330

Using the PowerScan™ PD9330

The PowerScan™ PD9330 normally functions by capturing

and decoding bar codes. The reader is equipped with an

aiming system which helps to aim the target.

Table 1. Aiming System

PowerScan™ PD9330 provides an aiming system. If

enabled, a partial trigger press produces a red spot, which

should be aimed over the code center to get the best

reading performance, see figure (1) above. By completely

pressing the trigger the scan line appears to start the

code scanning (2).

Scan Line Position

Code scanning is performed along the scan line emitted

from the reading window. This line must cross the entire

code. The best reading angles are indicated in the figure

below:

Datalogic PD9330 Quick Reference Guide

Other manuals for Datalogic PD9330