Datalogic PowerScan D8300 User Manual

Enter Configuration
Exit and Save Configuration
Ì$+;Î
16-KEY DK MODEL PARAMETERS
Ì$-?Î
146
LAST CODE SHOWN TIMEOUT
After the CODE transmission, the last code read will be shown on the display for a configurable
timeout (LAST CODE SHOWN TOUT).
NOTE: Just as in the settings for the standard Powerscan, the display has an active timeout
before going in OFF state. This timeout has a higher priority than the LAST CODE SHOWN
TOUT, so the two parameters should be combined to get the desired result.
Disabled
1 second

2 seconds
5 seconds
10 seconds
25 seconds
40 seconds
60 seconds
80 seconds
99 seconds

Datalogic PowerScan D8300 Specifications

General

Brand	Datalogic
Model	PowerScan D8300
Category	Barcode Reader
Language	English