HOST CONFIGURATION STRINGS
129
CODE SELECTION (continued)
DESCRIPTION STRING
Composite Code disabled ANA0
enabled ANA1
Discard Linear disabled ANB0
Part enabled ANB1
e
= a number from the HEX/Numeric Table
e
= a number in the range 0001-3600
READING PARAMETERS
DESCRIPTION STRING
Trigger Mode trigger level BAA0
trigger pulse BAA1
Trigger Type normal trigger BAB0
software trigger BAB1
Flash On Duration BF0
f
Flash Off Duration BF1
f
Beeper Tone tone 1 GBA1
tone 2 GBA2
tone 3 GBA3
tone 4 GBA4
Beeper Volume off GBB0
low GBB1
medium GBB2
high GBB3
Beeper Duration GBC
f
Reads per Cycle one read per cycle BCA0
multiple reads per cycle BCA1
Scan Timeout BEA
f
User Defined Beeper Tone tone 1 GBD1
tone 2 GBD2
tone 3 GBD3
tone 4 GBD4
User Defined Beeper Volume off GBE0
low GBE1
medium GBE2
high GBE3
User Defined Beeper Duration GBF
f
Perform User Defined Beep
∗∗
$?GGG
∗∗
this command carries out its specific function and does not need $+ and $-.
To Next Page
Loading...
Need help?
General
