Charging the Batteries
Quick Reference Guide 5
Charging the Batteries
Once the BC 90x0-BT is powered, you can charge the
reader's batteries. Place the PowerScan
™
PBT9501-AR into
the BC 90x0-BT cradle. The Reader LED on the cradle/bat-
tery charger turns red.
The battery is completely charged when the Reader LED
on the cradle/battery charger turns green.
The battery can also be charged in the spare battery slot
(BC91xx models only) or using the Multi Battery Charger
accessory.
Changing the Batteries
1. Push the button at the bottom of the handle as
shown to release the battery.
2. Pull down to remove the battery.
WARNING
Do not incinerate, disassemble, short terminals
or expose to high temperature. Risk of fire, explo-
sion. Use specified charger only. Risk of explo-
sion if the battery is replaced by an incorrect
type. Dispose of the batteries as required by the
relevant laws in force.
To Next Page
Loading...
