Datalogic PowerScan PBT9501-AR - Operating Mode; Scan Mode

Operating Mode
16 PowerScan™ PBT9501-AR
Operating Mode
Scan Mode
The imager can be set to operate in one of several scan-
ning modes. See the PRG for more information and set-
tings for any of the options:
Trigger Single (Default) — When the trigger is pulled, scan-
ning is activated until one of the following occurs:
•a programmable duration
1
has elapsed
• a label has been read
•the trigger is released
Trigger Hold Multiple — When the trigger is pulled, scan-
ning starts and the product scans until the trigger is
released or “maximum scan on time”
1
has elapsed. Read-
ing a label does not disable scanning. Double Read Time-
out
1
prevents undesired multiple reads in this mode.
Trigger Pulse Multiple — When the trigger is pulled and
released, scanning is activated until programmable dura-
tion
1
has elapsed or the trigger has been pulled again to
transition to another state. Double Read Timeout
1
pre-
vents undesired multiple reads while in this mode.
Flashing — The reader flashes
1
on and off regardless of the
trigger status.
Always On — No trigger pull is required to read a bar code.
Scanning is continually on. If the trigger is pulled, the
reader acts as if it is in Trigger Single (Default) Mode. Dou-
ble Read Timeout
1
prevents undesired multiple reads
while in this mode.
1. See the Product Reference Guide (PRG) for more infor-
mation