Datalogic PowerScan PBT9501-AR - Linking the Reader; Link Datalogic RF Devices to Base; Linking to a Bluetooth Adapter in Serial Port Profile (Slave) Mode

Linking the Reader
8 PowerScan™ PBT9501-AR
Linking the Reader
Link Datalogic RF Devices to Base
For RF devices, before configuring the interface it is nec-
essary to link the handheld with the base.
To link the handheld and the base, press the trigger to
wake up the handheld and mount it into the base. If the
reader was previously linked to another base, you must
first press and hold the button on the base (>5 seconds),
then scan the
Unlink bar code before re-linking to the new
base.
Linking to a Bluetooth Adapter in Serial Port
Profile (Slave) Mode
1. Install any drivers provided with the Bluetooth
adapter.
2. Scan the
Enable RF Link to Server label below to make
the scanner visible to the host computer.
3. Use the host computer’s Bluetooth manager to “Dis-
cover new devices” and select "Datalogic Scanner." If
you receive an error message, it may be necessary to
disable security on the device.
4. Use an RS-232 terminal program to see incoming
data on the port designated by the computer's Blue-
tooth manager.
Unlink
Enable RF Link to Server