Reading Parameters
16 PowerScan™ PD9130
Reading Parameters
Move the reader toward the target and center the aiming,
then pull the trigger to capture and decode the barcode.
See Using the PowerScan™ PD9130 on page 3 for more
information.
As you read code symbols, adjust the distance at which
you are holding the reader.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green
spot. Use the bar codes that follow to specify the duration
of the good read pointer beam after a good read.
ENTER/EXIT PROGRAMMING MODE
Disabled
Short (300 ms)
Medium (500 ms)
Long (800 ms)
To Next Page
Loading...
Need help?
General
