CONNECTIONS
DISCONNECTING
THE CABLE
USB
WEDGE
RS232
<Æ
tl
c
\J
NOTE
Prior
to connection,
verify
that
your
connection
cable
matches
your
TouchrM Light interface model
(see
product
label). Avoid connecting intefface cables, which are not
compatible with
your
TouchlM
Light model.
COMPLIANCE
LED CLASS
Class
1 LED
product.
This
product
conforms
to 8N60825-1:2001.
FCC
COMPLIANCE
l\,4odifications
or changes to
this equipment without the
expressed written approval
of
Datalogic
could void
the authority
to use the equipment.
This device
complies with PART 15
of the FCC Rules. Operation is
subject to the
following two
conditions:
(1)This
device
may
not cause harmful interference, and
(2)
this device must
accept any interference received, including
interference which
may cause
undesired operation.
This equipment has
been tested and found to comply with the limits for a
Class
B
digital device,
pursuant
to
part
15
of the FCC Rules. These limits are designed to
provide
reasonable
protection
against
harmful interference in
a
residential
installation.
This equipment
generates,
uses and can radiate radio frequency
energy
and,
if not installed
and used in accordance
with
the
instructions, may
cause harmful interference to radio communications. However, there is no
guarantee
that interference will not occur in a
particular
installation. lf this
equipment does cause harmful interference to radio or television reception, which
can be
determined byturning the equipment offand on, the user is encouraged to
try to correct the interference by
one
or more of the following measures:
-
Reorient or relocate
the
receiving
antenna.
-
lncrease
the separation between the equrpment and receiver.
-
Connect the
equioment into an outlet on a circuit different from
that to
which
the
receiver
is connected.
-
Consult
the dealer or an experienced radioiTv
technician for help.
POWER
SUPPLY
This
device
is
intended to be connected to a
UL
ListediCSA
Certified
computer
which supplies
power
directly to the reader or else be supplied by a UL Listed/CSA
Certified Power Unit marked
"Class
2" or LPS
power
source
rated
5
V, minimum
150 mA, which supplies
power
directly to the
reader via
the
power
connector of
the
caDte.
WEEE
PATENTS
This
product
is licensed
under the
following
U.S.
patent:
6,158,661
This
product
is covered by
one or more of the following
patents:
U.S.
patents
5,917,176t 5,992,744, 6,010,073; 6,305,606 B1; 6,517,003 82; and
6,712,271 82
European
patents
789,315 81;822,508 B1; 829,814 B1; 851,378 B1; 895,175 B1;
and
'1,205,871
Bl
Additional
patents pending.
COMPLIANCE
\rf
//ç+\
-
To Previous Page
Loading...
Need help?
General
Weight and Dimensions
