Datamax-ONeil RL3 - Page 67

www.datamax-oneil.com E-1
Code
Conditions Listing
0
No Conditions
1
Remove a Label
2
Waiting for a GPIO Signal
3
Thermal Printhead is Warm
4
Print Engine is Calibrating Sensors
5
FLASH is being Erased
6
FLASH is being Written
7
Network is Being Initialized
8
Print Engine is NOT Calibrated
9
Parser is in HEX DUMP Mode
10
Verifier/GPIO Mode
11
Print Engine in Print Test Rate Mode
12
Waiting for Additional Data
13
Motor is Warm
14
RFID is Active
15
Paper is Out
16
Battery is Charging
17
Battery is Dis-Charging
18
Wired Ethernet - 802.3 - Is Active
19
Wireless Ethernet - 802.11 - Is
Active
20
Bluetooth
®
- 802.15 - Is Active
21
Battery Charging
22
AC Plugged In
23
WIFI Attempting to Connect
24
WIFI Radio is OFF
NOTE: Codes listing is for notification information only; no user interaction required.