www.datamax-oneil.com 4
Your printer utilizes an external auto-ranging power supply to charge its battery. Before using your
printer, the battery should be fully charged. The printer cannot be operated through AC power alone and
requires the battery to be installed. Ensure that the operating ranges of the power supply are compatible
with your electrical service (see Appendix A) then follow these instructions:
The maximum operating temperature of the printer is 50°C (122ºF). However, the maximum
operating temperature for charging when used with a Datamax-O’Neil power supply is limited to
40°C (104ºF). Please charge the printer in a suitable location that meets this temperature
requirement.
There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used
batteries properly.
1) Remove the Battery from the printer. Then remove the red Battery Isolator.
312
2) Re-install the Battery into the printer. Align the release tab with the same side as the charge
contacts and lock the battery into position. The latch should click into place when seated properly.
312
To Next Page
Loading...