Datamax Mark II M-4206 Installation Instructions

7
Using the HTML Pages
The printer has resident HTML (Web) pages that allow configuration of network and printer settings as well as performing
status queries and diagnostic tests. To configure the Print Server and other internal printer settings you can access the
printer via HTML pages using any Web browser.
1. In your Web browser, choose File -> Open.
2. Enter the IP address of the Print Server and press Enter. (The default IP Address is:
192.0.0.192)
; Note: Consult with your system administrator for all necessary address, printer, and protocol information. To change
these settings you will be asked for an authentication password. Type sysadm and click “Apply”.
Next you should see the Print Server’s Unit Information page:

Datamax Mark II M-4206 Specifications

General

Print Resolution	203 dpi
Type	Label Printer
Print Method	Thermal Transfer
Max Print Speed	6 inches per second
Memory	16 MB SDRAM, 8 MB Flash
Interfaces	USB, Serial, Parallel
Media Width	4.5 inches
Media Length	0.25" to 99"
Max Print Width	4.25 inches (108 mm)