To select the video signals to be output from the camera.
BARS
Camera generated colour bar signals are output.
CAM. AUTO KNEE OFF
The images shot by camera are output. The AUTO KNEE
circuit does not work. MANUAL KNEE is set as the camera
recorder's initial setting.
CAM. AUTO KNEE ON
The images shot by the camera are output. The AUTO
KNEE circuit works.
NOTE:
AUTO KNEE circuit will not be effective if DRS
(Dynamic Range Stretch) function is enabled. It is also
possible to allocate the MANUAL KNEE and DRS functions
via the menu settings on the camera.
Allows selection of the video amplifier’s gain depending
on the lighting conditions that are present in the camera’s
location.
Moving the switch upwards increases the gain in dB steps.
Moving the switch downwards decreases the gain in dB
steps.
AWB / ABB switch with LED
This switch is used to trigger Auto White Balance (AWB)
or Auto Black Balance (ABB) adjustment.
AWB: White balance is adjusted automatically. When the
W.BAL switch is set to A or B at this time, the value to
which the balance was adjusted will be stored in memory
A or memory B.
ABB: Black balance is adjusted automatically. This value
will be stored in a dedicated ABB memory.
LED ON: Auto white balance / auto black balanc
Auto white balance / auto black balance
completed.
LED stops blinking and goes off: Auto white balance /
auto black balance error.
To Next Page
Loading...
