26
5. SPA
OFF
Figure 12.27
> Press menu up/down buttons to toggle between SPA MODE on and off;
> Press
menu/setting select once your preferred SPA MODE is displayed;
> This will then take you back to the first setting menu;
> If the ChloroMatic Nipper is left untouched for ~ 30 seconds, or the
menu/setting cancel (go back)
button is pushed, the display reverts to the HOME screen.
12.6 ACTIVATING SPA MODE AND COVER MODE SIMULTANEOUSLY
Should it be necessary to run SPA MODE and COVER MODE simultaneously, the cell duty cycle is only
reduced by 80% That is, the cell duty cycle isn’t reduced by 80%, followed by a further 80%. The HOME
screen display will toggle between showing COVER and SPA.
12.7 ACTIVATING WINTER MODE
A pool’s exposure to UV contributes significantly to the pool’s total chlorine demand. Ie the amount of
chlorine the pool uses. Bather load is also a significant contributor to the pool’s total chlorine demand. In
winter, the pool’s chlorine demand is typically far less. Unless otherwise altered, if the cell is producing
chlorine, it is producing at 100% current (output). WINTER MODE reduces the cell’s current (output) to 85%.
For example:
• If the ChloroMatic Nipper is on for 10 hours per day, the CHLORINE OUTPUT is set to 100%, the WINTER MODE
is off: the ChloroMatic Nipper cell duty cycle is 10 hours. The cell current will be operating at 100% capacity;
• If the ChloroMatic Nipper is on for 10 hours per day, the CHLORINE OUTPUT is set to 100%, but the
WINTER MODE is on: while the ChloroMatic Nipper cell duty cycle is still 10 hours, the cell current will only
be operating at 85% capacity.
To turn on WINTER MODE:
70% – 09:35 AM
CHLORINE OUTPUT
Figure 12.28
> From the HOME screen, press menu/setting select.
> The display will show this screen:
To Next Page
Loading...
Need help?
General
