DAVID 5 - Page 35

10/31/2016 DAVIDDAVID5Manual
http://www.david3d.com/en/support/david5/printversion 35/37
↑ | Shape Fusion | Comparison
"Comparison" allows to measure signed distances between two surfaces:
1. Select a scan and set it as TestObject .
2. Select a scan and set it as ReferenceObject .
3. Enter the desired Tolerance[mm] .
4. Click on Compare .
5. Add data tips on the reference scan with AddReferenceMarker ( + ).
↑ | 3D Viewer
Introduction
Installation
Setup
Calibration
Scanning
Shape Fusion
3D Viewer