DAVID 5 - Setup

10/31/2016 DAVIDDAVID5Manual
http://www.david3d.com/en/support/david5/printversion 4/37
Introduction
Installation
Setup
Connections
Camera Positioning
Camera Setup
Projector Setup
Calibration
Scanning
Shape Fusion
3D Viewer
After successfully connecting all devices, you typically walk through the following steps:
1. Setup Type
Select DAVIDSLS‐X as "Setup Type".
2. Projector Setup
Here you can select on which display device the stripe pattern is shown. Select your projector from the list,
it will then project the setup pattern.
3. Working distance