Why does my Davis Instruments Vantage VUE Weather Station inside humidity seem too high or too low?
Ensure the console isn't near a humidifier or dehumidifier. Check the calibration number and adjust if necessary. If the inside humidity is low and the inside temperature is too high, turn off the console backlight.
Why does my Davis Instruments Weather Station outside temperature reading seem too high?
Check the calibration number and adjust if necessary. The ISS (Integrated Sensor Suite) may need to be relocated away from radiant heat sources.
What to do if my Davis Instruments Vantage VUE Weather Station console locks up?
Reset the console by removing both AC and battery power, then restore the power. If this happens frequently when using AC power, plug the AC power adapter into a surge suppressor or use batteries, which can last up to a year.
How to fix incorrect sunrise and sunset times on Davis Instruments Vantage VUE Weather Station?
Check your latitude, longitude, time zone, and daylight saving time settings. The console calculates sunrise and sunset times based on these settings.
Why is the inside temperature reading too high on my Davis Instruments Vantage VUE?
The console backlight may be on, or the console might be in direct sunlight. Ensure the console or sensor isn't touching an exterior wall that heats up or near a heat source like lamps or appliances. Also, check the calibration number and adjust it if necessary.
What to do if my Davis Instruments Vantage VUE display is blank?
If the display is blank, the unit is likely not receiving power. Check the power adapter connections and consider replacing the batteries.
Why does my Davis Instruments Weather Station display show dashes instead of weather data?
The Integrated Sensor Suite (ISS) might not be transmitting data. Alternatively, the console might not be receiving the signal. It is also possible that a reading has exceeded the limits indicated in the specifications table, potentially due to calibration numbers. Check the ISS manual or troubleshoot reception problems. Verify the calibration number and adjust if necessary.
Instructions for registering your Vantage Connect online using an Activation Code received via email.
Steps to take if the status LEDs on the Vantage Connect are not active.
General| Console Display Type | LCD |
|---|---|
| Wind Direction Range | 0 to 360° |
| Wind Direction Accuracy | ±3° |
| Temperature Accuracy | ±1°F (±0.5°C) |
| Humidity Accuracy | ±3% |
| Solar Radiation Range | 0 to 1800 W/m² |
| Solar Radiation Accuracy | ±5% |
| UV Index Range | 0 to 16 |
| Wireless Transmission Range | 1000 feet (300 meters) |
| Update Interval | 2.5 seconds |
| Temperature Range | -40°F to +150°F (-40°C to +65°C) |
| Humidity Range | 0 to 100% RH |
| Rain Collector Resolution | 0.01 inches (0.2 mm) |
| Wind Direction Resolution | 1° |
| Power Source (Integrated Sensor Suite) | Solar panel with battery backup |
| Power Source (Console) | AC adapter or 3 C batteries |
| Wind Speed Accuracy | ±2 mph (±3 kph) or ±5%, whichever is greater |
| Rainfall Accuracy | ±4% |
| Operating Temperature | -40°F to +140°F (-40°C to +60°C) |
| Wind Speed Range | 0 to 150 mph (0 to 241 km/h, 0 to 67 m/s) |
To Next Page
