DAVIS Weather Wizard III User Manual

Temperature
Weather Wizard III Page 19
To Change the Date
1. Press TIME once or twice to select the date.
2. Use ENTER to set the correct date (see “Using the Enter Key” on page 16 for instruc-
tions).
3. Press any key to exit.
To Use the Time Alarm
For instructions on how to use the time alarm, see “Alarms” on page 24.
TEMPERATURE
The Weather Wizard III measures and displays two temperature readings. One
reading is from the temperature sensor inside the console. The other reading is
from the external temperature sensor. Both readings may be displayed in either
˚F or ˚C in increments of either 1˚ or 0.1˚.
The Weather Wizard III also records high and low temperatures for each set of
temperature readings.
To Display Current Temperatures
1. To display inside temperature, press TEMP.
The inside temperature reading and the word INSIDE appear on the display.
2. To display outside temperature, press TEMP again.
The outside temperature reading and the word OUTSIDE appear on the display.
INSIDE AND OUTSIDE TEMPERATURE DISPLAYS
To Change the Unit of Measure
1. Press TEMP once or twice to select inside or outside temperature, as desired.
2. Press UNITS until the desired unit of measure and resolution (1˚F, 0.1˚F, 1˚C, 0.1˚C)
appear in the display.
To Display High and Low Temperatures
1. Press TEMP once or twice to select inside or outside temperature, as desired.
2. Press UNITS to select ˚F or ˚C as desired.
3. Press RECL to display the high.
After a few seconds, the display will show the time the high was recorded, and
then the date it was recorded.
MPH
N
NE
SW
NW
SE
EW
S
INSIDE
C
TEMPERATURE
Inside Temperature: 24˚COutside Temperature: 68.7˚F
F
MPH
N
NE
SW
NW
SE
EW
S
OUTSIDE
TEMPERATURE

DAVIS Weather Wizard III Specifications

General

Brand	DAVIS
Model	Weather Wizard III
Category	Weather Station
Language	English