Auto Scan
Weather Wizard III Page 27
AUTO SCAN
The Weather Wizard III can be set to perform an automatic scan of the weather
functions. Each reading appears on the display (in the unit of measure you last
used) for approximately four seconds before being replaced by the next func-
tion in the scan routine. There is a pre-programmed scan routine which reviews
weather functions in the order given below.
• Current, High, and Low Inside Temperature
• Current, High, and Low Outside Temperature
• Current and High Wind Speed
• Current Wind Direction
• Current and Low Wind Chill
• Daily and Accumulated Rainfall
You may also program a customized scan routine to review only the functions
you desire. The console can store one customized scan routine in addition to
the pre-programmed scan.
Note: You can enter time and/or date into the customized scan routine, though they are not included in the
pre-programmed scan routine.
To Start and Stop a Scan Routine
1. Press SCAN to begin the pre-programmed routine.
2. To begin the customized scan routine (if you have entered one), press SCAN again.
3. To stop the scan routine, press any key except SCAN or ENTER.
To Program a Customized Scan Routine
1. Press SCAN.
2. Press ENTER.
The compass rose disappears and the word SCAN appears. After a few seconds,
the display will begin to alternate between the word SCAN and the normal dis-
play to let you know you are in scan entry mode.
SCAN ENTRY MODE
3. Press the appropriate keys to display the first function you wish to scan.
For example, press TEMP twice and RECL once for High Outside Temperature.
4. If desired, press UNITS to change the unit of measure.
OUTSIDE
TEMPERATURE
To Next Page
Loading...
Need help?
General
