3KP64 - 1.13
3000PLUS WITH 5D64 INSTRUCTION MANUAL V. SB.2
Daytronic Corporation
2211 Arbor Blvd. Dayton, OH 45439 • (800) 668-4745
Tel: (937) 293-2566 • Fax: (937) 293-2586 • www.daytronic.com
A SAMPLE CONFIGURATION is installed with the
software, to let you see typical 3000PLUS setup
entries. Select
Open... from the Configurator File
menu and double-click on “SAMPLE.”
14. To UNINST
ALL the 3KP Configurator Software,
a. Go to the Windows popup
Start menu, select
Settings, and then select Control Panel. Then
double-click on the button called
Add/
Remove...
(or Add or Remove Programs).
b. Select “3000PLUS Configurator” from the list of
programs, and click the appropriate button to
remove it.
c. When asked whether you’re sure you want to
completely remove the 3KP Configurator and
all its components, answer
Yes to uninstall (or
No to abort). You may be asked whether
you’re sure you want to remove
MSCOMM32.OCX and COMDLG32.OCX
(which are shared components). If in doubt,
answer
No.
d.
NOTE: This procedure will NOT delete any
“*.mdb” 3KP CONFIGURATION FILES currently
in your Configurator installation directory which
were created through the Configurator soft-
ware. In fact, if you have created any such files,
you will be told that the directory itself cannot
be removed (click
Ok to exit this message). A
hidden file named “TOC.GID” may remain in the
installation directory after removal of the Con-
figurator software. This file is harmless, and will
not affect any later reinstallation of the Configu-
rator.
1. INTRODUCTION
To Next Page
Loading...
