3KP64 - 3.3
3000PLUS WITH 5D64 INSTRUCTION MANUAL V. SB.2
Daytronic Corporation
2211 Arbor Blvd. Dayton, OH 45439 • (800) 668-4745
Tel: (937) 293-2566 • Fax: (937) 293-2586 • www.daytronic.com
always be pressed twice for every parameter: once to
acknowledge the parameter and once to accept its
presently displayed value.
For example, after pressing
SETUP five times, you
should be at the
LIMITS stage (as indicated by the ST
and LM lights). Pressing ENTER will then display the
current value of the first parameter within this stage:
LIMITS, which can be either “ON” or “OFF” (as
explained in the following section).
Note that
• You must be at the first parameter of a setup stage
in order to use the
SETUP button to step to the next
stage.
• The SETUP stepping process works in both
“CHANGE SETUP” and “VIEW ONLY” modes.
EXITING SETUP MODE
At any point within the setup procedure, pressing
and keeping it depressed for about 2 seconds will
return the instrument to normal run-time operation.
To Next Page
Loading...
