By including every form of processing necessary to drive the signal from the mixer to the
power amp, the DriveRack™ allows you to eliminate all other processing devices that are nor-
mally found in traditional DriveRack™ systems of the past.
The 480 DriveRack™ Loud Speaker Management System includes four balanced XLR inputs,
as well as eight balanced XLR outputs, which can be routed for any configuration. The 481
and 482 DriveRack™ units feature the identical processing power of the 480 DriveRack™, but
utilize streamline front panel interfaces. In addition, the 481 offers euroblock connectors as
opposed to the XLR connectors found in the 480 and 482 DriveRack™ units.
The 480, 481 and 482 include features such as: pre-crossover EQ, dual RTAs, notch filters,
speaker delays, multiple crossovers, compression/limiting, as well as numerous other features.
Dual RTA analyzers can be run simultaneously with RTA source inputs capable of being remote-
ly switched on the fly. The 480 DriveRack™ is fully programmable from the front panel, and
can control other devices in a network including the 481 and 482. The entire system can be
controlled via the 480R DriveRack™ remote controller or through the included GUI interface.
Monitor Application Guide
DriveRack™
dbx
5
To Next Page
Loading...
