DEC DECpc 433 - Initial Troubleshooting

Troubleshooting
Initial Troubleshooting
Follow this general procedure to initially troubleshoot components of your
DECpc 433 Workstation:
1. Verify that power is applied by checking the power on
indicators (system box, SCSI expansion box, monitor,
and connected peripherals).
2. Check for loose cables and connections.
3. Tum the system on. If the system fails to boot, tum it
off, wait 20 seconds, and then tum it back on.
4. Observe any POST messages. Refer to Chapter 2,
"Power-on Self Test", for a listing of POST messages
and beep codes. Take corrective action.
5. Seek assistance. Contact your system administrator or
network coordinator for LAN related problems.
6. Seek assistance. Contact Digital Customer Service for
software
and hardware problems.
7. If you need to return a failed part, pack it in its original
container and return it to Digital for service.
For your convenience, you can place orders by phone, by mail, or in person at
any Digital sales office.
Call 1-800-DIGITAL between 8:30 a.m. and 8:00 p.m. Easter:n time, or write to:
Digital
Equipment Corporation
P.O. Box CS2008
Nashua, NH 03061
DECpc 433 Workstation Service Guide
2-15