Dectris EIGER 2 - Using a Fixed IP

4.1.2. Using a Fixed IP
If you want to access the detector control unit using a xed IP network address, plug the network cable into
the service port of your detector control unit pre-congured for a xed IP. See the Technical Specications for
the network port conguration of your detector control unit and congure your network accordingly.
If you use e.g., a laptop to access the detector control unit directly for the initial conguration, you can use the
following network settings on the laptop:
Table 4.1: Network Settings
IP Adress 169.254.254.100
Subnet Mask 255.255.0.0
Default Gateway not required
DECTRIS EIGER
®
2 User Manual v1.8.2 9 | 36