Dectron, Inc. March 2012
DECTRON
DSH/DSV/RSH/DBH/RBH Series Dehumidifier Owner’s Manual
Startup Adjustments
Data subject to change without notice.
240
IMPORTANT!
Once the pool water and room air have reached design conditions, final adjustments must be made.
Return to the installation at this point and follow the instructions below.
For units without motorized bypass damper, the bypass damper must be fully open once the room
temperature is above 78°F.
The chart below shows approximate temperatures inside the DRY-O-TRON
®
.
The pool-water-heater discharge temperature is given as an approximate guide only and can vary with pool
heater size.
Adjust all temperature and relative humidity set points to design conditions (see Operation - Set Points for
detailed instructions). Design conditions can be found on the unit nameplate.
IMPORTANT!
After final adjustments are made, ensure that the Start-up Report and Warranty Registration form is completely
filled in and a copy returned to the Dectron factory to register the warranty.
Leave the Owner’s Manual and the completed start-up form with the DRY-O-TRON
®
.
2
1
3
4
DRY-O-TRON
®
SIDE VIEW SECTION
DEHUMIDIFYING
COIL
BLOWER
AIR REHEAT
COIL
POOL WATER
HEATER
5
Ex: Room air
82°F 50% rh
POOL WATER IN
80°F
POOL WATER
OUT
Standard Operating Temperature Differences (°F)
Dehumidification
Temperature Point #
Space Cooling
Space Cooling and
Pool Water Heating
123
50 82
82
82
66
66
65
Pool Heating
47 82 65
50
47
4
95
72
72
82
5
84
84
96
96
Risk of contact with moving parts. Can cause injury or death.
This product contains rotating parts and V-belt drives. Do not approach any moving
parts while electric power is applied to unit. Use only approved devices (e.g. locking
safety switch), to disconnect, lockout, and tagout all sources of electrical energy before
working inside the unit cabinet. Allow adequate time for rotating parts to stop. Follow
all applicable safety regulations.
WARNING
STARTUP
To Next Page
Loading...
Need help?
General
