EasyManuals Logo

Dectron DRY-O-TRON Supervisaire DSV 040 User Manual

Default Icon
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #243 background imageLoading...
Page #243 background image
Dectron, Inc. March 2012
Owners Manual
DSH/DSV/RSH/DBH/RBH Series Dehumidifier
Data subject to change without notice.
243
DRY-O-TRON® DS Series
Startup Report & Warranty Registration
Warranty void unless this form
is completed and submitted
within 1 week after startup.
See unit nameplate for the following information:
For units with air-cooled
air conditioning only:
See compressor nameplate(s) for the following information:
Installation Name:
Installation Address:
Dectron Representative Firm:
Supply
Airflow: CFM
Hot-Gas
Tube Size(s) (O.D.)
if any
Comp 1
Model #
Comp 1
Serial #
Comp 2
Model #
Comp 2
Serial #
Comp 3
Model #
Comp 3
Serial #
Comp 4
Model #
Comp 4
Serial #
Comp 5
Model #
Comp 5
Serial #
Comp 6
Model #
Comp 6
Serial #
Comp 7
Model #
Comp 7
Serial #
Comp 8
Model #
Comp 8
Serial #
Supply Blower
Belt Size (if any)
Return Blower
Belt Size (if any)
Min. Exh. Blower
Belt Size (if any)
Max. Exh. Blower
Belt Size (if any)
Unit
Model:
Unit
Serial #:
Unit
Ref #:
Cir. 1 Cir. 2 Cir. 3 Cir. 4 Cir. 5 Cir. 6 Cir. 7 Cir. 8
Liquid
Tube Size(s) (O.D.)
Maximum Allowable
Length of Tubes: ft.
if any
if any
Proper air distribution:
Proper duct design:
Proper ventilation
provided:
Vapor retarder installed
properly:
Chemicals stored in the
Mechanical Room:
Adequate service access
provided:
Vibration isolation provided:
Flex duct installed at Inlet and
Outlet of DRY-O-TRON®:
Condensate drain installed:
Condensate drain tested:
Condensate pump (if any)
installed properly:
Branch-circuit disconnect
switch installed:
Remote condenser (if any)
installed properly:
Remote operator panel (if any)
installed properly:
Outdoor temperature sensor
(if any) installed properly:
Wire connections checked for
tightness:
Startup checklists complete:
Blower rotation on 3-phase
motors correct:
Airflow and blower speed
adjusted:
Refrigerant charge OK:
Fault codes displayed on
operator panel:
Set points are at design
conditions:
Bypass damper open in room
temp. > 78° F:
Measured Airflow: cfm
Yes
No
N/A
Begin with the unit turned OFF. See safety warnings on a previous page.
page 1 of 4
See unit nameplate.
STARTUP
6.37

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dectron DRY-O-TRON Supervisaire DSV 040 and is the answer not in the manual?

Dectron DRY-O-TRON Supervisaire DSV 040 Specifications

General IconGeneral
BrandDectron
ModelDRY-O-TRON Supervisaire DSV 040
CategoryController
LanguageEnglish

Related product manuals