EasyManua.ls Logo

Dedrone RF-360 - Safety Information

Dedrone RF-360
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IM-Inst-RF360en v0.4
Dedrone
5
Safety
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measu-
res:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/television technician for help.
Modifications: Any modifications made to this device that are not approved by Dedrone GmbH may
void the authority granted to the user by the FCC to operate this equipment.
Caution!
To prevent permanent exposure, the device should be installed and operated with a
minimum distance of 20 cm (7.87 in) between the device and your body.
1.3 Safety Information
Read, follow and retain all of the following safety instructions. Heed all warnings on the unit and in
the operating instructions before operation.
Warning! Setup should be carried out by trained personnel only, in accordance with the
national electric code, ANSI/NSPA, and all local country codes.
Danger of life due to electric shock.
Whenever any damage to the device has occurred live components could be touched,
which can lead to lethal electric shocks. Such damages can be:
the AC cable is damaged
the patch cable is damaged
an object has fallen on the device
the device has been dropped, or its enclosure has been damaged
the device does not operate normally when the user follows the operating instruc-
tions correctly
When the RF-360 is plugged into an AC power source, there is always voltage applied to
the internal electronics. Unplug the devices from the power source by disconnecting the
AC cable and patch cable immediately. Make sure, that the power socket is always acces-
sible.
Refer all servicing to qualified service personnel. This device has no user-serviceable
internal parts. Do not attempt to service this device yourself.
Adjust only those controls specified in the operating instructions. Improper adjustment
of other controls may cause damage to the unit.