DEEPBLU cosmiq+ - SECTION 5 - INSTRUCTIONS FOR USE; 5.1 WATCH MODE; 5.1.1 Dive Plan Function; 5.1.2 Planning a Dive

14
COSMIQ
+
Dive Computer
Back to Contents
5.2.4 After your dive
Upon surfacing from a dive, or when you are shallower than 2 m (6 ft), your COSMIQ
+
will remain in Scuba Mode for 5 minutes. If you surface for fewer than 5 minutes and
then descend again, your COSMIQ
+
will consider this a continuation of the previous
dive and the calculations will continue from where they left off.
After 5 minutes, your COSMIQ
+
will begin to count the Surface Interval Time. It will be
displayed on the Watch Mode screen and counted upwards in hours and minutes.
Any additional descent will be considered a new dive.
The dive data recorded during each dive is accessible through Log Mode.
No-Dive Time, No-Fly Time and Dynamic Lock
After every dive, the No-Fly icon
will be shown in the bottom-right corner of the
display. The No-Fly Time is based on the calculations of your desaturation time
accordingtoyouractualdiveprole.TheNo-FlyTimewillbecounteddownwards
every half hour.
Depending on the estimated level of residual nitrogen in your body, your COSMIQ
+
may display a No-Dive Time underneath the No-Dive icon , counted down in half-
hour intervals.
With a conservative or normal safety factor setting, a No-Dive Time of over 1 hour
will lead to a temporary lock(the letters SUF appear on screen). This is to encourage
youtoconductaminimumsurfaceintervaltoooadexcessnitrogen.Whenyour
OVERVIEW
SAFETY
OPERATION
PAIRING
DIVING
DIVE LOGS
CARE
SPECS
WARRANTY
GLOSSARY
DIVING